Epoxy resin adhesive RAPID GLUE, fast drying time

Temperature tolerance from -35°C to about +100°C.
Usage:
Step 1: The surface to be bonded must be cleaned before use, dry and free of oil, silicone, lubricants, wax, etc. To ensure perfect adhesion, the surface should be hardened with sandpaper.
Step 2: Cut off the round safety lock buttons with a knife. Mix Component A with Component B by squeezing for about 10-20 seconds on a piece of cardboard, metal or similar. To do this, you can use the mixing paste provided, remove excess glue. Connect/mix both parts and press together for about 4-5 minutes. Ideal processing temperature: 15-20°C.
Step 3: After gluing is complete, insert the cartridge into the black leak guard with the tabs facing upwards to prevent leaks.

General characteristics

• Crystal clear hardening
• Mixing ratio 1:1
• Mixing time: ca 15-20 sec.
• Processing time (20°C): approx 4-5 min.
• Curing time: approx 4-5 min.
• Hard after about 20 min.
• Processing temperature: -15°C to + 30°C
• Recommended ambient temperature: 15°C – 25°C
• Heat resistance: from ca -35°C to ca +100°C approx.
• Fully chemically cured after a maximum of 24 hours
• Resistance to petrol, water and oil
• Resistant to abrasion and impact, as well as to ageing and the environment

Applications
Ultra-fast bonding of wood, metal, porcelain, rubber, many plastics, concrete, stone, ceramics, glass and many other similar materials.

Safety advice
OHT: Contains N-(-3-dimethylaminopropyl)-1,3-propylenediamine. Harmful if swallowed. Causes skin irritation. May cause an allergic skin reaction. Causes serious eye damage. Harmful by inhalation. May cause respiratory irritation. Toxic to aquatic organisms, long-lasting effects. EUH 205 Contains epoxy compounds. May cause allergic reactions. Do not inhale dust/fumes/gas/fumes/vapour. Wear protective gloves/protective clothing/goggles/face protection. IN CASE OF ACCIDENT ON SKIN (or hair): take off all contaminated clothing immediately. Rinse skin with water/under shower. IN CASE OF EYE INJURY: Rinse gently with water for several minutes. If possible, remove contact lenses. Continue rinsing. Avoid release into the environment. Keep locked. Dispose of contents/container in accordance with local/regional/national/international regulations.