DIPON®DiamondCraft UV resin

More info:
Operating temperature: -55°C to + 122°C
Viscous (1500 mPa*s/15°C, 1300 mPa*s/22°C)
Hardness: Shore D 88 after 24 hours
Tensile strength: 22Mpa
Hardening performance: about 825 mj/cm²
Cure time 2cm: (UV 9w-18w 120-150s, 36w 90-150s)
Solids content: 99,9%
Glass transition temperature: 63°C
Percentage of elongation lost: 160%
Waterproof, non-fogging
Anti-Streak Formula
Shelf life: approx. 12 months in original sealed packaging at 21-25°C.

USE PERSONAL PROTECTIVE EQUIPMENT!

INSTRUCTIONS FOR USE: Before use, warm the DIPON® DiamondCraft UV resin to at least 20°C, e.g. using a 10-minute water bath at about 45-60°C. A final material temperature of about 25°C is ideal for working with resin. Slowly squeeze the DIPON® DiamondCraft UV resin out of the bottle to avoid excessive bubbles.
Store the material in the original bottle and protect it from direct UV rays. The maximum moulding height is 2 cm (20 mm). DIPON® DiamondCraft UV resins should not be mixed with solvents as the heat generated during the curing process may cause irreparable damage to the workpiece and harmful gases may be generated. Depending on the UV radiation and the lamp intensity, the workpiece may initially appear slightly yellowish, which becomes transparent after complete cooling. Hold the UV lamp 9w-36w: approx. 90-180 seconds depending on lamp wattage, different pre-tests are necessary as wattage may vary from manufacturer to manufacturer. It is possible to allow the workpiece to cure in daylight if desired. Instructions for opaque paints: Opaque paints require the material to be applied in several coats and possibly also the backside to be covered with resin and fixed with a UV lamp. The material hardens when exposed to UV radiation!

WARNING!
H315 Causes skin irritation. H317 may cause allergic skin reactions. H319 Causes severe eye irritation. P101 Keep the product packaging or label handy in case of medical advice. P102 Keep out of reach of children. P261 Avoid inhalation of vapours. P280 Wear protective gloves/goggles/face protection. P305+P351+P338-In case of spillage: rinse gently with water for several minutes. If possible, remove contact lenses. Continue rinsing. P314 Seek medical advice if you feel unwell. P501 Dispose of contents/container in accordance with local/regional/national/international regulations.